There are various reasons, however, you can check whether it is the brake lights or the tail lights to see which are the parts having problems. You probably won't need the cleaner but I'm anal with this stuff. There are many causes for tail light constantly staying on while the car is turned off: A broken brake light switch, damaged trailer light plug, faulty brake light switch stopper, broken wiring harness. (just slightly as not to break them or bend them too much) I sprayed them with the contact cleaner an let dry, then i reassembled it and it was good. I also did this to the pins in the wire harness end. Pull the roller out and bend the 2 tabs out towards the circuit board to make a solid contact once its put back in. You'll see the roller tabs and the circuit board from there. The black back box comes off easily using a small flathead screw driver.( There are little tabs on each side that need to be pride apart. By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them. Then on your dimmer switch there are 2 (possibly 3, mine might have been missing one.) more screws that hold the switch to the panel, you have to remove them to get the dimmer out and apart. Dashlights on - Answered by a verified Chevy Mechanic We use cookies to give you the best possible experience on our website. A broken switch may only work on certain modes, or may cause them to come on and off intermittently and erratically. If the headlight switch fails or wears out it can cause problems operating the headlights. They have tabs on them that you have to squeeze to remove them. One of the most common symptoms of a faulty headlight switch is issues switching between headlight modes.

There will be 2 wire harnesses you will need to pull out to remove it completely. It was alittle tricky to pull up but if you pull on the left side up and out, you'll see there are 4 little tabs at the top of the panel that kinda snap in.( or you can lower your steering wheel for ease of removel) Be gentle so you don't break them. Cadillac Deville mk8 fuse box engine compartment. To access the fuse block, push in the two tabs located on the top and the bottom of the fuse block cover. Remove them and pull from the bottom first. The front Bussed Electrical Center (BEC) is located next to the engine on the passenger’s side of the vehicle. Well on my car there is 2 screws to the right and left under the steering wheel. Victor wrote:What's the procedure for getting the dimmer control out? I have to tap on mine too to make the dash light up.I'll try to explain as best as I can.

Accent dashlights